HOME
PRODUCTS
INFO
EVENTS
ENQUIRY
  STORAGE
• Keep the motor dry and clean.
• Store within the temperature range ( -20°C - +40°C ).
• Energise heaters if fitted, or use desiccant.
• Rotate the shaft weekly.
• Every 3 months, check the insulation resistance. If less than 10dry out.

  MECHANICAL INSTALLATION
  Lifting
• Always use correct lifting facilities.
• Note: Maximum hand lift is 20kg below shoulder, and above ground level.
• The eyebolts are to support the motor only.
• Eyebolts are designed for vertical lifting
• Ensure a level mounting surface.
• Ensure a correct fastner torques.
• Ensure gaskets, seal and guards are correctly fitted.
• Ensure adequate ventilation and space for maintenance.


• Before working on a machine, ensure that it is switched off, and the power source is isolated.
• Check insulation resistance of all windings with 500V dc Megger. If less than 10 dry out.
• Check overload setting.
• Heaters, if fitted, will be live when the motor is stationary.
• Mains cables must be correctly sized.
• Check terminal arrangements; Tight connection; Driven equipment is free; And rotation (uncoupled).
• Terminal box lids must be fitted after connection and testing.


  MAINTENANCE AND SPARE PARTS
• Remember to isolate power source before any maintance.
• Periodic maintenance should be done every 2000 running hours, or every 3 months.
  e.g. check for visible damage, such as cracked fans, covers, feet, frames etc.
• Clean free of dust, dirt, fibres etc, from motor frame and fan cover.
• Secure fastners, cables and earth leads.
• Replace bearings every 3 years.
• Never hammer a bearings. Always use an extractor.
• Avoid damaging windings, when removing a rotor.